Once the concrete has been trowelled smooth a large thin broom is used to create a textured finish.
Broom finish concrete driveway ideas.
This is a normal type of broom finish we do on a lot of patios pool decks sidewalks and driveways.
For a slip resistant finish wait 5 minutes then sweep a nylon bristle concrete broom across it 90 degrees to the foot traffic.
Window pane concrete finish scoring can be combined with wide tooling of the surface to create a window pane effect.
A concrete sealer could be applied with some grit additive to keep it from being too slippery when it gets wet.
This is because the sealer will protect the concrete from road salts stains mold etc.
Wait 6 hours before walking on it.
Broom finish driveway concrete driveways kmm decorative concrete northbridge ma.
This must be done during the final finishing of the concrete.
The typical process for a broom finish is.
Some of the aggregate would be exposed giving you a nice smooth decorative look to your sidewalk and patio.
Wait for the bleed water to evaporate.
Strike off with a screed.
There s some disagreement here.
One is you could grind or polish the surface which would remove the rough broom finish and smooth the surface of the concrete.
In this video we will show you how we broom finish concrete slabs.
In many cases.
Although with low water cement ratio exterior concrete with the proper amount of air there might not be.
Remove the weatherstripping after 20 minutes.
Spread the resurfacer until it s between 1 8 and inch thick.
Broom finished concrete gets its name from the application of a broomed texture to the concrete as it is being finished.
Should i seal the broom finished concrete.
Yes it is a good idea to seal the broom finished concrete.